Calculation methods

Electric Vehicle Calculation Methods

Formulas and assumptions behind our EV charging, range, battery life, fleet, and total cost calculators.

EV charging time & cost

Charge Time (h) = Battery Capacity (kWh) ÷ Charger Power (kW) ÷ Charger Efficiency

Charger efficiency captures AC-to-DC conversion losses, typically 85–95% depending on charging level. Cost is then charge energy delivered (kWh) multiplied by the local electricity rate, with optional demand charges layered in for Level 3 / DC fast charging on commercial tariffs.

Used by: EV Charging Cost Calculator, Cost to Charge a Tesla Calculator, EV vs Gas Cost Calculator, Cost to Charge an EV at Home Calculator

EV vs. ICE total cost

EV elec $/yr = miles × (kWh/100mi ÷ 100) × $/kWh · ICE fuel $/yr = (miles ÷ mpg) × $/gal · Fuel savings = ICE − EV · Maint. savings = ICE maint − EV maint · Total annual = fuel + maint · Breakeven (yr) = premium ÷ total annual · Net = (total annual × yrs) − premium

This calculator compares the ongoing running costs of an electric vehicle against a comparable internal-combustion-engine (ICE) car, then weighs those savings against the EV's higher upfront price. Annual EV Electricity Cost ($) = Annual Miles × (EV Efficiency (kWh/100mi) ÷ 100) × Home Electricity Price ($/kWh); at 12,000 mi/yr, 30 kWh/100mi, and $0.17/kWh, that is $612/yr. Annual ICE Fuel Cost ($) = (Annual Miles ÷ ICE mpg) × Gasoline Price ($/gal); at 12,000 mi/yr, 25 mpg, and $3.10/gal, that is $1,488/yr. Annual Fuel Cost Savings = ICE fuel cost − EV electricity cost ($876). Annual Maintenance Savings = ICE maintenance − EV maintenance ($600), reflecting EVs' fewer moving parts, no oil changes, and regenerative braking (DOE and Consumer Reports put EV maintenance 40–50% lower). Total Annual Savings = fuel savings + maintenance savings ($1,476). Breakeven Point (years) = EV Price Premium ÷ Total Annual Savings — at a $3,000 premium and $1,476/yr, about 2.03 years. Net Savings Over Ownership Period = (Total Annual Savings × Years) − EV Price Premium — ($1,476 × 5) − $3,000 = $4,380 over 5 years. The model assumes home charging at the residential electricity rate; public and DC fast charging typically run $0.39–0.50/kWh versus ~0.17/kWh at home, so drivers relying on public charging see smaller savings. It also excludes one-time home charger installation and any tax credits/incentives, which would shorten the breakeven further. Data sources: EIA residential electricity prices (2026); U.S. DOE EV efficiency and maintenance cost studies; Consumer Reports vehicle maintenance cost analysis; EIA gasoline price tracking.

Open the calculator →

Fleet electrification ROI

Fuel $/veh = (diesel $/mi − elec $/mi) × miles · Maint. $/veh = (diesel maint − elec maint) × miles · Total $/veh = fuel + maint · Fleet $ = total $/veh × vehicles · Upfront premium = (EV premium × vehicles) + infra − (incentives × vehicles) · Payback (yr) = upfront premium ÷ fleet $

This calculator scales the single-vehicle EV-vs-ICE tradeoff up to an entire fleet, weighing per-vehicle fuel and maintenance savings against the one-time cost of switching. Annual Fuel Cost Savings per Vehicle ($) = (Diesel/Gas Fuel Cost ($/mile) − Electric Fuel Cost ($/mile)) × Annual Miles per Vehicle; at $0.20/mile diesel, $0.045/mile electric, and 25,000 mi/yr, that is (0.20 − 0.045) × 25,000 = $3,875/yr. Annual Maintenance Savings per Vehicle ($) = (Diesel/Gas Maintenance Cost ($/mile) − Electric Maintenance Cost ($/mile)) × Annual Miles per Vehicle; at $0.08 and $0.04/mile, that is $1,000/yr. Total Annual Savings per Vehicle ($) = fuel savings + maintenance savings — $4,875. Total Annual Fleet Savings ($) = Total Annual Savings per Vehicle × Number of Vehicles — $4,875 × 10 = $48,750/yr. Total Upfront Cost Premium ($) = (EV Price Premium per Vehicle × Number of Vehicles) + Charging Infrastructure Cost − (Available Incentives per Vehicle × Number of Vehicles); at a $20,000 premium, $100,000 infrastructure, and $0 incentives across 10 vehicles, that is $300,000. Fleet Payback Period (years) = Total Upfront Cost Premium ÷ Total Annual Fleet Savings — $300,000 ÷ $48,750 ≈ 6.15 years. The model uses flat per-mile fuel and maintenance costs and excludes residual value differences, financing costs, and depot electricity demand charges, all of which can shift real-world payback. Data sources: U.S. Department of Energy (DOE) vehicle fuel cost and maintenance cost studies; commercial fleet electrification case studies; EV charging infrastructure cost benchmarks from industry reports.

Open the calculator →

V2G (Vehicle-to-Grid) revenue

Annual exported (kWh) = kWh/session × days/yr · Gross revenue = exported × $/kWh · Degradation cost = exported × $/kWh wear · Net revenue = gross − degradation

Vehicle-to-Grid (V2G) lets a plugged-in EV export stored energy back to the grid when it is most valuable, earning revenue from the spread between cheap charging and valuable discharge.

Data sources: U.S. Department of Energy (DOE) V2G pilot program reports; utility V2G program documentation (Eaton, Nuvve, Fermata, others); battery degradation research from MIT, NREL, and vehicle manufacturers; published V2G rate schedules from California ISO, ISO-NE, and regional utilities.

Read the full explanation on the calculator page →

Charging station load

L1 load = L1 count × 1.4 kW · L2 load = L2 count × 7.2 kW · DCFC load = DCFC count × power rating · Total = L1 + L2 + DCFC · Peak demand = Total × simultaneity %

Sizing the electrical service for an EV charging site starts from the connected load of every charger on the property, then applies a simultaneity (diversity) factor to estimate the peak demand the service actually has to deliver. Total Connected Load - Level 1 (kW) = Number of Level 1 Chargers × 1.4 kW, the SAE J1772 standard 120V Level 1 rating. Total Connected Load - Level 2 (kW) = Number of Level 2 Chargers × 7.2 kW, the typical 240V Level 2 rating. Total Connected Load - DC Fast Chargers (kW) = Number of DC Fast Chargers × DC Fast Charger Power Rating (kW), reflecting the specific DCFC units installed (commonly 50-350+ kW). Total Connected Load (kW) = Level 1 + Level 2 + DC fast; at the defaults (0 L1, 10 L2 at 7.2 kW, 2 DCFC at 150 kW), that is 0 + 72 + 300 = 372 kW. Site Peak Electrical Demand (kW) = Total Connected Load × (Simultaneity/Diversity Factor ÷ 100) — at 50%, 372 kW becomes 186 kW, the demand the transformer, feeder, and service panel must be sized to deliver. Sites with mostly DC fast chargers often run higher simultaneity (60%+) since sessions are short and concentrated, while mixed sites with many Level 2 chargers often run lower, around 40-50%. Data sources: SAE J1772 standard (Level 1/2 power ratings); DCFC charger manufacturer specifications (Tesla Supercharger, Electrify America, EVgo, others); EV charging infrastructure planning guides from DOE and NREL; utility interconnection studies on EV charging load diversity.

Open the calculator →

DC fast charger sizing

Session (min) = (kWh/session ÷ kW) × 60 · Charging-hrs/day = (vehicles × session min) ÷ 60 · Utilization % = (charging-hrs ÷ (stalls × op-hours)) × 100 · Connected (kW) = stalls × kW · Peak demand (kW) = connected × simultaneity %

This calculator ties the operational sizing of a DC fast charging site (how many stalls serve the traffic) to its electrical sizing (how much utility service those stalls demand).

Data sources: DC fast charger power ratings and charging time data from EV charging equipment manufacturers (Tesla Supercharger, Electrify America, EVgo, ABB, others); EV battery sizes and fast-charging energy additions from vehicle specifications; electrical load diversity factors from utility interconnection standards (IEEE 1547, NEMA); charging station design practices from EVSE industry guidelines.

Read the full explanation on the calculator page →

EV battery life (linear degradation)

Remaining % at year N = 100% − (rate × N) · Remaining range = original range × (remaining % ÷ 100) · Years to warranty threshold = (100% − threshold) ÷ rate

This calculator uses a simplified linear degradation model — the same approach most EV manufacturer warranties use for planning purposes — where usable battery capacity fades by a fixed percentage of original capacity each year, and driving range fades proportionally with it.

Data sources: Geotab 2026 EV battery degradation study (22,700+ vehicles, 2.3% average annual rate); EV manufacturer warranty specifications (Tesla, Ford, Chevrolet, Hyundai, others — 70% capacity / 8-year / 100,000-mile); NREL battery aging research; real-world EV fleet data from commercial operators.

Read the full explanation on the calculator page →

EV range & efficiency

Usable capacity (kWh) = battery capacity × (usable % ÷ 100) · EPA range (mi) = usable capacity × efficiency (mi/kWh) · Real-world range (mi) = EPA range × (1 − derate ÷ 100)

This calculator works in three steps that mirror how an EV turns battery capacity into driving distance. Usable Battery Capacity (kWh) = Battery Capacity (kWh) × (Usable Battery Percentage (%) ÷ 100); automakers reserve a small buffer at the top and bottom of the charge range to protect long-term battery health, so at 75 kWh gross and 95% usable, that leaves 71.25 kWh of drivable energy. EPA-Rated Range (miles) = Usable Battery Capacity (kWh) × Vehicle Efficiency (miles per kWh); at 71.25 kWh and 3.3 mi/kWh, that is about 235 miles, matching how the EPA derives range ratings from the FTP-75 and HWFET test cycles. Real-World Estimated Range (miles) = EPA-Rated Range (miles) × (1 − Driving Condition Derate (%) ÷ 100); the derate captures how real-world conditions shrink range below the EPA figure — highway speeds above 70 mph cut roughly 15% from aerodynamic drag (which rises roughly with the square of speed), cold weather below freezing cuts roughly 20% from reduced battery chemistry efficiency and cabin heating draw, and the two combined can cut 30%. At 235 miles EPA-rated with a 15% highway derate, real-world range is about 200 miles. The derate field auto-fills from the driving-conditions dropdown but stays editable for any custom penalty. Data sources: EPA vehicle efficiency testing procedures (FTP-75 and HWFET cycles); EV manufacturer efficiency specifications; real-world EV range studies from Geotab, AAA, and independent testing; aerodynamic drag and cold-weather penalty research from NREL and DOE.

Open the calculator →

Fleet charging schedule optimizer

Total daily kWh = vehicles × kWh/vehicle · Shifted = total × shiftable % · Unopt $ = total × peak rate · Opt $ = shifted × off-peak + remaining × peak · Unmanaged kW = vehicles × charger kW · Managed kW = unmanaged × simultaneity % · Demand $/mo = (unmanaged − managed) × $/kW · Annual = daily savings × 365 + demand savings × 12

This calculator quantifies the savings from two independent levers a charging management system pulls: shifting energy into cheaper off-peak hours, and staggering charging to reduce peak demand. Total Daily Energy Required (kWh) = Number of Vehicles × Charging Energy Required per Vehicle per Day (kWh); at 20 vehicles and 50 kWh/vehicle, that is 1,000 kWh/day. Energy Shifted to Off-Peak (kWh) = Total Daily Energy × (% Shiftable ÷ 100) — 800 kWh at 80%. Energy Remaining at Peak Rate (kWh) = Total Daily Energy × (1 − shiftable % ÷ 100) — 200 kWh. Daily Energy Cost — Unoptimized ($) = Total Daily Energy × Peak Period Electricity Rate ($/kWh); at 1,000 kWh and $0.25/kWh, that is $250/day. Daily Energy Cost — Optimized ($) = (Energy Shifted × Off-Peak Rate) + (Energy Remaining × Peak Rate); at 800 × $0.10 + 200 × $0.25, that is $130/day. Daily Energy Cost Savings = Unoptimized − Optimized — $120/day. Unmanaged Peak Demand (kW) = Number of Vehicles × Charger Power per Vehicle (kW); at 20 × 7.2 kW, that is 144 kW. Managed Peak Demand (kW) = Unmanaged Peak Demand × (Managed Simultaneity Factor ÷ 100); at 30%, that is 43.2 kW. Monthly Demand Charge Savings ($) = (Unmanaged − Managed Peak Demand) × Peak Demand Charge ($/kW); at (144 − 43.2) × $15, that is $1,512/month. Annual Total Savings ($) = (Daily Energy Cost Savings × 365) + (Monthly Demand Charge Savings × 12); at $120/day and $1,512/month, that is $43,800 + $18,144 = $61,944/year. The two savings streams are independent and additive: energy savings depend on the rate spread and shiftable share, while demand savings depend on charger power, simultaneity, and the demand charge rate. Data sources: U.S. commercial electricity rate structures and demand charge benchmarks; EV charging management software case studies; utility rate schedules from major regional utilities; DOE fleet electrification cost analysis.

Open the calculator →

← All calculation methods