Battery Size & Payload Penalty Calculator
Every kilowatt-hour of battery an electric truck carries has weight, and weight is cargo it cannot haul. This calculator turns a daily route, an efficiency figure, and a reserve margin into the installed battery size, the pack weight, and the payload an electric truck gives up versus the diesel engine, transmission, tanks and fuel it no longer carries.
Pack-level LFP is roughly 0.12-0.16 kWh/kg; illustrative.
Engine, transmission, tanks and fuel that an electric truck does not carry.
miles × efficiency × (1 + reserve)
required ÷ usable window
10,498 lb
4,987 lb vs diesel
Illustrative; use manufacturer specs.
Results update live as you type. For planning and field-check estimates — always verify against applicable standards and equipment ratings.
How we calculate this →Range and payload trade off directly in an electric truck. A 250-mile duty cycle needs roughly 667 kWh installed, a pack weighing nearly 4.8 tonnes, and that can cost about 5,000 lb of cargo capacity versus diesel in this example. Shorter routes, mid-shift charging and weight allowances are the usual ways to claw it back. See the EV Range & Efficiency Calculator for the driving-range side of this tradeoff; a Truck Range, Payload & Cold-Weather Derate Calculator is on the roadmap.
How battery size and payload penalty are calculated
This calculator sizes an electric truck battery from a daily duty cycle, then converts that battery into weight and the cargo it displaces. Four quantities tie the calculation together.
Required Energy (kWh) = Route Miles per Day × Efficiency (kWh/mile) × (1 + Reserve (%) ÷ 100). The reserve margin covers detours, headwinds, cold-weather derate, and the bottom of the charge you never want to hit; at 250 miles, 2.0 kWh/mile, and 20% reserve, that is 250 × 2.0 × 1.20 = 600 kWh.
Installed Battery (kWh) = Required Energy ÷ (Usable Battery Window (%) ÷ 100). Operators avoid the full charge range to protect cell life, so the pack must be larger than the energy actually consumed; at a 90% usable window, 600 ÷ 0.90 = 666.7 kWh installed.
Pack Weight (kg) = Installed Battery (kWh) ÷ Pack Energy Density (kWh/kg). Pack-level LFP density runs roughly 0.12-0.16 kWh/kg today; at 0.14 kWh/kg, 666.7 ÷ 0.14 = 4,762 kg. Pack Weight (lb) = Pack Weight (kg) × 2.20462, about 10,497 lb.
Net Weight Penalty (kg) = Pack Weight (kg) − Diesel Powertrain & Fuel Weight Offset (kg). An electric truck sheds the diesel engine, transmission, fuel tanks, and fuel, so only the net added weight displaces cargo; at a 2,500 kg offset, 4,762 − 2,500 = 2,262 kg. Net Weight Penalty (lb) = Net Weight Penalty (kg) × 2.20462, about 4,987 lb.
Trucks operate against legal gross-combination weight limits, so every kilogram of net battery weight is a kilogram of cargo the truck cannot carry on a maxed-out run. Shorter routes shrink the required energy (and therefore the pack), mid-shift megawatt charging lets a smaller battery cover the same duty cycle, and many jurisdictions grant electric trucks a weight allowance precisely because the powertrain is heavier. Data sources: U.S. DOE and NREL heavy-duty EV battery sizing and energy density studies; manufacturer Class 8 electric tractor specifications; FHWA federal bridge weight limits and state EV weight allowances. Verification: with defaults (250 miles, 2.0 kWh/mile, 20% reserve, 90% usable window, 0.14 kWh/kg, 2,500 kg offset), Required Energy = 600 kWh, Installed Battery = 666.7 kWh, Pack Weight = 4,762 kg (10,497 lb), Net Weight Penalty = 2,262 kg (4,987 lb).
Frequently asked questions
Why does battery weight matter?
Trucks have legal weight limits, so every pound of battery can displace cargo.
Can I use a smaller battery?
Yes, if you add mid-route charging or shorten the route.
Do electric trucks get weight allowances?
Some jurisdictions allow extra weight; rules vary, so check yours.
Why a usable window?
Operators avoid the full range of the battery to protect its life.