Back to Natural Gas & Behind-the-Meter Power
Natural Gas & Behind-the-Meter Power tools

Gas Price Sensitivity Calculator

Gas is the swing variable in any behind-the-meter decision. See how fuel cost, all-in cost and annual cost move across a range of gas prices, how much each $1/MMBtu shifts the bill, and the break-even gas price where grid power becomes cheaper.

Typical ranges: combined-cycle 6,200–7,000; reciprocating engines 8,000–9,000; aeroderivative turbines 8,500–10,000; simple-cycle frame turbines 9,500–11,000.

Use delivered price (Henry Hub plus basis and transport).

Capital recovery plus fixed and variable O&M. Get this from the Behind-the-Meter Gas Plant LCOE Calculator.

The delivered grid price you would pay instead.

Gas prices are volatile; update to current delivered prices.

Base all-in cost
$66.00/MWh

fuel + non-fuel at base gas price

Annual cost (base)
$52,034,400

all-in × annual generation

Cost change per $1/MMBtu
$6,701,400/yr

heat rate ÷ 1000 × annual generation

Break-even gas price vs grid
$5.65/MMBtu

(grid price − non-fuel) ÷ fuel use

Gas price sensitivity

788,400 MWh/yr
Fuel cost ($/MWh) All-in cost ($/MWh)
Gas price ($/MMBtu)Fuel costAll-in costAnnual cost
$2.00$17.00/MWh$49.00/MWh$38,631,600
$3.00$25.50/MWh$57.50/MWh$45,333,000
$4.00base$34.00/MWh$66.00/MWh$52,034,400
$5.00$42.50/MWh$74.50/MWh$58,735,800
$6.00$51.00/MWh$83.00/MWh$65,437,200
$8.00$68.00/MWh$100.00/MWh$78,840,000
$10.00$85.00/MWh$117.00/MWh$92,242,800

Results update live as you type. For planning and field-check estimates — always verify against applicable standards and equipment ratings.

How we calculate this →
Insight

At 8,500 Btu/kWh, every $1/MMBtu move in gas price shifts the cost of a 100 MW plant by about $6.7 million per year. The tool's break-even line shows how high gas can rise before grid power becomes cheaper, which is the key question behind any behind-the-meter decision. For fuel cost per MWh, see the Heat Rate & Fuel Cost per MWh Calculator; for full project economics, see the Behind-the-Meter Gas Plant LCOE Calculator.

How gas price sensitivity is calculated

Gas price is the single biggest swing variable in behind-the-meter generation, so the sensitivity model holds everything else fixed and walks the fuel cost across a range of prices. Annual Generation (MWh) = Plant Capacity (MW) × 8,760 × Capacity Factor (%) ÷ 100 — at 100 MW and 90% CF that is 788,400 MWh. Fuel Use (MMBtu/MWh) = Heat Rate (Btu/kWh) ÷ 1,000, so an 8,500 Btu/kWh plant burns 8.5 MMBtu per MWh. Fuel Cost ($/MWh) = Fuel Use × Gas Price ($/MMBtu), and All-In Cost ($/MWh) = Fuel Cost + Non-Fuel Cost, where non-fuel cost bundles capital recovery plus fixed and variable O&M (about $32/MWh at the defaults, from the Behind-the-Meter Gas Plant LCOE Calculator). Annual Cost ($) = All-In Cost × Annual Generation.

Two derived figures make the sensitivity actionable. Cost Change per $1/MMBtu ($/yr) = Heat Rate ÷ 1,000 × Annual Generation — at 8,500 Btu/kWh and 788,400 MWh that is 8.5 × 788,400 = $6.7 million per year for every dollar the gas price moves, which is why fuel price risk dominates behind-the-meter economics. Break-Even Gas Price ($/MMBtu) = (Grid Price − Non-Fuel Cost) ÷ Fuel Use — the gas price at which self-generation costs the same as buying grid power. At $80/MWh grid and $32/MWh non-fuel, that is (80 − 32) ÷ 8.5 = $5.65/MMBtu: below it, self-generation wins; above it, the grid is cheaper.

The sensitivity table and chart sweep gas prices from $2 to $10/MMBtu so you can read fuel cost, all-in cost and annual cost at each point, with the base case highlighted. The model uses a single annual average gas price — it does not capture intra-year volatility, seasonal swings, or hedging — and holds heat rate, capacity factor and non-fuel cost flat. Henry Hub is the US benchmark, but delivered prices add regional basis and transport; use your actual delivered price. Data sources: US gas priced on higher heating value (HHV); typical heat rates 6,200–11,000 Btu/kWh by technology. Verification: 100 MW, 8,500 Btu/kWh, 90% CF, $4/MMBtu gas, $32/MWh non-fuel, $80/MWh grid → annual generation = 788,400 MWh, fuel use = 8.5 MMBtu/MWh, base fuel = $34/MWh, base all-in = $66/MWh, annual cost = $52.0M, cost per $1/MMBtu = $6.70M/yr, break-even gas = $5.65/MMBtu.

Frequently asked questions

What is Henry Hub?

The main US natural gas pricing benchmark, quoted in dollars per MMBtu.

Why not use Henry Hub directly?

Delivered prices add regional basis differentials and pipeline transport costs on top of the Henry Hub benchmark.

How can I protect against price swings?

Fixed-price gas contracts, financial hedges, or lower-heat-rate (more efficient) equipment that reduces exposure per MWh.

What is break-even gas price?

The gas price at which self-generation costs the same as grid power — below it you save, above it the grid is cheaper.

Does this cover price volatility within a year?

No. It uses a single annual average gas price and does not model seasonal swings or intra-year volatility.